HDAV and Ethernet Extender Over One Cat5e/6 (HDBaseT)

This Extender is based on the HDBaseT technology. It extends your HD display with the resolutions of 1080p/60Hz up to 330 feet (100 meters) away from your HDMI or DVI-D source using one CAT5e/6 cable. It also extends Ethernet and provides an IR back channel to control AV sources using the same CAT5e/6 cable. The three Ethernet ports on both the Sender and Receiver are connected to standard network devices such as 100Base-T routers and hubs. Built-in IR extender function allows IR remote control of Source devices from remote viewing location by sending IR commands received in the vicinity of the Display back to the Source devices.

• Support HDCP 
• Support uncompressed HDMI signal. 
• Enables HDMI10.2 Gbps and 100Mbps Ethernet in parallel over a single 100m Cat5e/6 cable. 
• Supports 340MHz/3.4Gbps per channel (10.2Gbps all channel) bandwidth. 
• Support 1080p@60Hz@48bit pixels 
• Support 3D pass-through.
• Support CEC pass-through.
• Supports uncompressed audio such as LPCM.
• Supports compressed audio such as DTS Digital, Dolby Digital（including DTS-HD and Dolby True HD)
• There are 3 standard Ethernet ports with switching capabilities on each unit. There is no difference 12、between the 3 and any type of connection topology is permitted.
• Built-in IR extender function allows IR remote control of Source devices from remote viewing location by sending IR commands received in the vicinity of the Display back to the Source devices.
• CAT5e/6 cable follows the standard of IEEE-568B